NASLite Network Attached Storage

www.serverelements.com
Task-specific simplicity with low hardware requirements.
It is currently Sun May 04, 2025 7:30 pm

View unanswered posts | View active topics


Board index » v2.x NASLite Products » NASLite-2

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
BIG44G
 Post subject: Help with Sys Log
PostPosted: Thu Mar 29, 2007 10:36 pm 
Offline

Joined: Sun Feb 18, 2007 9:22 pm
Posts: 11
Is this the connection speed in my sys log?

Mar 25 21:57:01 user.info kernel: eth0: 100Mbps Full-duplex operation.

I have a gigabit card, and my switch indicates that it is connected at gigabit speed. I am at the bottom of the learning curve, so I hope this is not to stupid a question.
Top
 Profile  
 
georg
 Post subject:
PostPosted: Fri Mar 30, 2007 2:11 pm 
Offline

Joined: Sat Nov 19, 2005 6:39 pm
Posts: 633
Location: California
BIG44G:

Yes, that is the current capacity of your ethernet connection.

Make sure to use a good cable that is properly rated for gigabit, otherwise the auto-sense capability in the switch or your NIC downgrades to 100mbps.

:) Georg
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » v2.x NASLite Products » NASLite-2

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 0 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group