NASLite Network Attached Storage

Both of my IBM HDDs give me error messages but are running fine else:

Disk-3 Hardware
IC35L080AVVA07-0, ATA DISK drive
attached ide-disk driver.
host protected area => 1
160836480 sectors (82348 MB) w/1863KiB Cache, CHS=159560/16/63, UDMA(100)
dma_timer_expiry: dma status == 0x61
dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }
dma_timer_expiry: dma status == 0x61
dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }
dma_timer_expiry: dma status == 0x61
dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }
dma_timer_expiry: dma status == 0x61
dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }

NOTE: Disk-3 is installed and available for use.

Disk-4 Hardware
IBM-DTLA-307030, ATA DISK drive
attached ide-disk driver.
host protected area => 1
60036480 sectors (30739 MB) w/1916KiB Cache, CHS=59560/16/63, UDMA(100)
dma_timer_expiry: dma status == 0x61
dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }
dma_timer_expiry: dma status == 0x41
dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }
dma_timer_expiry: dma status == 0x41
dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }
dma_timer_expiry: dma status == 0x41
dma timeout retry: status=0x58 { DriveReady SeekComplete DataRequest }

NOTE: Disk-4 is installed and available for use.

This two HDDs share an IDE channel on an ECS K7S5A mainboard.

Anybody any ideas?

TIA
Kelsey

Bad IDE cable is where I would start.

Mike