NASLite Network Attached Storage • View topic

View unanswered posts | View active topics

Board index » General » Hardware

All times are UTC - 5 hours [ DST ]

Problems with new HDD

Page 1 of 1

[ 3 posts ]

Previous topic | Next topic

Author

Message

Berserker

Post subject: Problems with new HDD

Posted: Thu Oct 19, 2006 9:54 am

Joined: Thu Oct 19, 2006 9:42 am
Posts: 1

Hello guys,
at first i have to sorry for my bad english, because i´m a german guy!

My problem is: my server can´t see and initial my new HDD seagate barracuda250gb.
the order is primary master-cdrom, primary slave-samsung sp1604n,
(logically jumpered as the same, or i´m wrong?)
primary master-seagate barracuda 250gb, primary slave-samsung sv0844a.
booting from cdrom... the nas can´t see the seagate i´ve tested many jumper settings! the hdd is brand new and runs if it becomes power.

Top

ALucas

Post subject:

Posted: Thu Oct 19, 2006 10:41 am

Joined: Fri Jun 16, 2006 5:09 am
Posts: 130

May be it's a dead disk. It happened to me 2 times in the last year...

Can you install the new disk in another PC and see if BIOS sees it?..

Top

mikeiver1

Post subject:

Posted: Thu Oct 19, 2006 9:22 pm

Joined: Sun Apr 02, 2006 9:05 pm
Posts: 1688
Location: Up State NY in the USA!!!!

Try putting the cdrom on the primary channel and the new HDD on the secondary channel. Also be sure the the ribbon cable is good. Give this a shot and it should boot, assuming that the drive is good.

Mike

Top

Page 1 of 1

[ 3 posts ]

Board index » General » Hardware

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 56 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum