NASLite Network Attached Storage

www.serverelements.com
Task-specific simplicity with low hardware requirements.
It is currently Sat Apr 27, 2024 4:30 am

View unanswered posts | View active topics


Board index » v1.x NASLite Products » NASLite+

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
rhendrix9
PostPosted: Sun Oct 30, 2005 11:55 am 
Offline

Joined: Mon Oct 24, 2005 11:54 am
Posts: 7
Location: Atlanta, GA
I setup naslite+ with a maxtor 160 hd, everything works fine.
I added a seagate 250, and the 160 was no longer found. The drives are set to use cable select.
I was able to format drive 2 (seagate) but drive 1 (maxtor) would not mount.

What are my solutions, I can think of three.
1. use jumper setting for master and slave instead of cable select ?
2. reformat drive 1 and 2 and see if they get recognized?
3. buy another seagate (and remove maxtor)?

What is most likely to solve my problem? :?:
Top
 Profile  
 
rhendrix9
 Post subject:
PostPosted: Sun Oct 30, 2005 5:01 pm 
Offline

Joined: Mon Oct 24, 2005 11:54 am
Posts: 7
Location: Atlanta, GA
or (drum role) option 4
4. BIOS
The bios was set for "None" on master but it set the slave to the seagate. When I went into the bios and changed the slave to also be "None", both drives appeared on the next boot, problem solved.

Thanks
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » v1.x NASLite Products » NASLite+

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 33 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group