NASLite Network Attached Storage

www.serverelements.com
Task-specific simplicity with low hardware requirements.
It is currently Thu May 28, 2020 1:20 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Tue Oct 03, 2006 12:56 pm 
Offline

Joined: Thu Jul 20, 2006 12:18 pm
Posts: 5
Location: Roswell, GA
I'm not sure how much RAM is in the machine I'm using for my NASLite+ 1.x server, and I'm curious to know whether it has enough to upgrade to NASLite-2 CDD. The machine doesn't have a monitor attached, so I can't see any messages generated while booting. Can anyone suggest an easy way to determine how much RAM is in this machine that doesn't involve opening it up or trying to find a spare monitor? Thanks!


Top
 Profile  
 
 Post subject:
PostPosted: Tue Oct 03, 2006 4:08 pm 
Offline

Joined: Wed Jan 04, 2006 2:18 pm
Posts: 172
Location: North Carolina, USA
use a web browser to go to http://YOUR NAS IP HERE/Info/System.htm

It will show you RAM about in the middle of the page in the Memory section.

Note this is "left over" memory after NASLite uses some for it's kernal so you need to round up some. Numbers shown are in K bytes. I have 64Meg installed and under the "total" column it shows 62548.


Top
 Profile  
 
 Post subject:
PostPosted: Tue Oct 03, 2006 4:27 pm 
Offline

Joined: Thu Jul 20, 2006 12:18 pm
Posts: 5
Location: Roswell, GA
Ah, that worked -- thanks very much for the tip! I had forgotten about the HTTP-based reports.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group