NASLite Network Attached Storage

www.serverelements.com
Task-specific simplicity with low hardware requirements.
It is currently Wed Dec 11, 2024 2:04 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Sun Sep 22, 2024 10:05 am 
Offline

Joined: Sun Nov 13, 2005 5:48 pm
Posts: 5
Location: Norfolk, UK
I have been running naslite for many years now and have just had a motherboard failure. I have replaced the board with Gigabyte GA-F2A88x-D3HP the old board was a GA-F2A88X-D3H.
I am having a problem with the unlock code. When first started I generated a new ID code and a restart after inputing that and saving config gave me what appeared to be a clean bill of health.
I had to switch off to finalise work on cable tidying etc and I left it off for 48 hours. At the next restart the unlock ID showed as invalid so I generated the unlock ID again entered it saved and did a restart. All ok again.
I had to shut down again and the same thing happens again and I am getting the same 2 codes being generated now. One will work until the next reboot then I generate again and get the second one repeated.
I am at a total loss as to why this is happening. Can any one offer a solution.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group