NASLite Network Attached Storage • View topic

View unanswered posts | View active topics

Board index » v2.x NASLite Products » NASLite-2

All times are UTC - 5 hours [ DST ]

How to replace a disk

Page 1 of 1

[ 2 posts ]

Previous topic | Next topic

Author

Message

peithos

Post subject: How to replace a disk

Posted: Sat Jul 18, 2009 8:42 am

Joined: Tue Apr 07, 2009 6:15 pm
Posts: 27

I have set up NASLite-2 on an old Pentium II PC with the OS on a 5GB HDD and 3 X 320 GB Seagate hard disks as storage.
The three 320 GB drives are showing as 3 individual disks. They are attached to the motherboard through a cheap PCI Raid card - but no RAID enabled, just using the card as an interface since it's not compatible with NASLite-2. All works fine.
Can I now swap out one of the 320GB drives and replace it with a 500GB drive, format the new drive and re-boot (all are PATA drives)? What do I need to watch for?

Top

mikeiver1

Post subject: Re: How to replace a disk

Posted: Sat Jul 18, 2009 7:44 pm

Joined: Sun Apr 02, 2006 9:05 pm
Posts: 1688
Location: Up State NY in the USA!!!!

Just make sure that the drive you format, the new drive, is the one. Format on a Linux FS is generally permanent.

Mike

Top

Page 1 of 1

[ 2 posts ]

Board index » v2.x NASLite Products » NASLite-2

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 23 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum