NASLite Network Attached Storage

This will soon be our standard platter.

Disk-3 Hardware Details:

MODEL: ATA ST31500341AS, v.SD17
INTERFACE: SCSI, HOST-1, BUS-0, TARGET-0, LUN-0





Filesystem Details:

tune2fs 1.27 (8-Mar-2002)
Filesystem volume name: NASLite-SE000121
Last mounted on:
Filesystem UUID: 82a15d7e-5e7a-4e24-a85f-84903b040ef0
Filesystem magic number: 0xEF53
Filesystem revision #: 1 (dynamic)
Filesystem features: has_journal filetype needs_recovery sparse_super large_file
Filesystem state: clean
Errors behavior: Continue
Filesystem OS type: Linux
Inode count: 183156736
Block count: 366282000
Reserved block count: 0
Free blocks: 113473736
Free inodes: 183155551
First block: 0
Block size: 4096
Fragment size: 4096
Blocks per group: 32768
Fragments per group: 32768
Inodes per group: 16384
Inode blocks per group: 512
Last mount time: Fri Dec 12 03:11:13 2008
Last write time: Fri Dec 12 03:11:13 2008
Mount count: 19
Maximum mount count: 36
Last checked: Fri Nov 21 01:51:02 2008
Check interval: 15552000 (6 months)
Next check after: Wed May 20 01:51:02 2009
Reserved blocks uid: 0 (user admin)
Reserved blocks gid: 0 (group admin)
First inode: 11
Inode size: 128
Journal UUID:
Journal inode: 8
Journal device: 0x0000
First orphan inode: 0






S.M.A.R.T. Status:

smartctl version 5.36 [i686-pc-linux-gnu] Copyright (C) 2002-6 Bruce Allen
Home page is http://smartmontools.sourceforge.net/

=== START OF INFORMATION SECTION ===
Device Model: ST31500341AS
Serial Number: 9VS0B2M3
Firmware Version: SD17
User Capacity: 1,500,301,910,016 bytes
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 8
ATA Standard is: Not recognized. Minor revision code: 0x29
Local Time is: Fri Dec 12 03:35:03 2008 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED

General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 617) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 255) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.

SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 118 100 006 Pre-fail Always - 185740434
3 Spin_Up_Time 0x0003 092 092 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 24
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 063 060 030 Pre-fail Always - 2056923
9 Power_On_Hours 0x0032 100 100 000 Old_age Always - 190
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 24
184 Unknown_Attribute 0x0032 100 100 099 Old_age Always - 0
187 Unknown_Attribute 0x0032 100 100 000 Old_age Always - 0
188 Unknown_Attribute 0x0032 100 100 000 Old_age Always - 0
189 Unknown_Attribute 0x003a 076 076 000 Old_age Always - 24
190 Unknown_Attribute 0x0022 070 061 045 Old_age Always - 505085982
194 Temperature_Celsius 0x0022 030 040 000 Old_age Always - 30 (Lifetime Min/Max 0/22)
195 Hardware_ECC_Recovered 0x001a 036 035 000 Old_age Always - 185740434
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0

SMART Error Log Version: 1
No Errors Logged

SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]


SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.

I'm confused Art. What is not happening in terms of SMART with that drive?

I'm not seeing the detailed results information the other drives produce. Perhaps I'm not reading correctly?

smartctl claims the drive is not in their database.