NASLite Network Attached Storage

My Naslite server has started beeping 3 times about every 20 seconds or so

1 low , then high then low tone

Can any body tell me what this meens cannot find in the book
and there is no listing in the server logs page
ended up turning it off

steve


Sorry got it wrong its the same beep pattern i think for shut down
But i havent told it to shutdown ?????????

Take a look at the manual where a table lists associated beep codes.

have looked at page 16 at the table thats where i got the shutdown pattern from.
why is it beeping when i haven't told it to shutdown ?
the machine that naslite is installed onto is an atx type and on shut down powers its self off.
At the moment its beeping its head off and i cannot find the reason.

there is not logs or errors on the status page

Did you check if one drive was not full, or if there were no Mirror errors?

Regards.

just checked that only got 3 drives in there with two of the drives set to mirror they dont apper to have any errors on them ( None reported anyway)
and they are not full yet running near 65% alarm set to 85%

Strange

Found out that my naslite beeping starts about the time i had a mirror time set
This drive has since been unmounted and removed as it has been replaced with a larger drive
anybody any ideas ?

Look at your log file and see if there is an error being reported there.

Mike