NASLite Network Attached Storage • View topic - changing to new system with 2.06

View unanswered posts | View active topics

Board index » v2.x NASLite Products » NASLite-2

All times are UTC - 5 hours [ DST ]

changing to new system with 2.06

Page 1 of 1

[ 2 posts ]

Previous topic | Next topic

Author

Message

diver86er

Post subject: changing to new system with 2.06

Posted: Tue Nov 13, 2007 12:27 am

Joined: Tue Jan 17, 2006 1:30 am
Posts: 5

changing from a old dell p3 to a new build system, does the hard drives have to go in the new system in the same order or can they change. All the hard drives are ide so i was going to start adding sata drives next. Harddrives are segate 300gb,400gb, and a 500gb. Thanks for any help.

Top

NickC

Post subject:

Posted: Tue Nov 13, 2007 4:07 am

Joined: Fri Jan 12, 2007 4:27 am
Posts: 577
Location: Scotland

NASLite will number the drives as it finds them - no problems in my experience with order changing. Bear in mind, if NASLite finds the SATA interface before the IDE interface it will number starting with the SATA drives, so your numbering will change every time you add a drive (possibly.....).

Top

Page 1 of 1

[ 2 posts ]

Board index » v2.x NASLite Products » NASLite-2

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 213 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum