NASLite Network Attached Storage

www.serverelements.com
Task-specific simplicity with low hardware requirements.
It is currently Wed Dec 11, 2024 4:40 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Thu Mar 26, 2015 7:15 pm 
Offline

Joined: Tue Nov 28, 2006 2:29 pm
Posts: 5
I run an old NASLite-M2 (v1.67 02-2012) and it has performed beautifully for years. Recently one of its drives failed and was replaced with a similar drive (Seagate ST1000NM0011). I can boot with no error, mount drives, and see them across the network. However, even though the general storage setting and the individual drives are set to RW, they only behave as though they are RO -- can't write or change anything on them.

Nothing changed, to my knowledge, in any of my NASLite configuration settings since the drive swap. And the same network computers/clients are in use; no change in their configuration or in the network config has taken place since that time. What am I overlooking?

One odd observation: I tried setting both drives to RO, saved the config, but the RW setting did not change after rebooting. So I set them back to the desired RW, but they still act like they are RO.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group