NASLite Network Attached Storage

Can anyone explain what is happening here?

0 - Disk-0, DEVICE-SDA, HOST-0, BUS-0, TARGET-0, LUN-0
* - Disk-1, DEVICE-SDB, HOST-1, BUS-0, TARGET-0, LUN-0 (Interestingly, this drive is accessible through shares -Shows up as Disk-1 with all files intact and accessible through Windows)
10 - Disk-10, DEVICE-SDK, HOST-2, BUS-0, TARGET-0, LUN-0
11 - Disk-11, DEVICE-SDL, HOST-3, BUS-0, TARGET-0, LUN-0
* - Disk-12, DEVICE-SDM, HOST-6, BUS-0, TARGET-0, LUN-0 (BOOT/CONFIG device)
2 - Disk-2, DEVICE-SDC, HOST-2, BUS-0, TARGET-0, LUN-0
3 - Disk-3, DEVICE-SDD, HOST-3, BUS-0, TARGET-0, LUN-0
4 - Disk-4, DEVICE-SDE, HOST-4, BUS-0, TARGET-0, LUN-0
5 - Disk-5, DEVICE-SDF, HOST-5, BUS-0, TARGET-0, LUN-0
6 - Disk-6, DEVICE-SDG, HOST-6, BUS-0, TARGET-0, LUN-0
7 - Disk-7, DEVICE-SDH, HOST-7, BUS-0, TARGET-0, LUN-0
8 - Disk-8, DEVICE-SDI, HOST-8, BUS-0, TARGET-0, LUN-0
9 - Disk-9, DEVICE-SDJ, HOST-9, BUS-0, TARGET-0, LUN-0

Why would Disk-1 be starred out from the Storage Configuration Menu? How do I access the configuration menu for Disk-1? What am I misunderstanding here?

I see some of this has already been covered in the following thread; viewtopic.php?f=22&t=3912

I will read through this, but if it doesn't help me I will come back here and post any new information/solutions.