NASLite Network Attached Storage

I'm stumped since neither Ralph nor I can seem to replicate this. What is the exit code that rsync reports? You can find it in the block above the log window and looks like this:



It's the line that reads "Close transport agent"

Here is the mirror log from Disk-2

2009/07/17 00:00:01 [4247] receiving file list
2009/07/17 00:00:01 [4247] rsync: opendir "/_NL_SWAP" (in Disk-1) failed: Permission denied (13)
2009/07/17 00:00:24 [4247] IO error encountered -- skipping file deletion
2009/07/17 00:00:24 [5053] .d..t.... ./
2009/07/17 00:00:24 [5053] >f..t.... :2eDS_Store
2009/07/17 00:00:24 [5053] >f..t.... .AppleDB/cnid2.db
2009/07/17 00:00:24 [5053] >f..t.... .AppleDesktop/.volinfo
2009/07/17 00:00:24 [5053] >f..t.... My Documents/:2eDS_Store
2009/07/17 00:00:24 [5053] >f..t.... My Documents/Nuclear Medicine/:2eDS_Store
2009/07/17 00:00:24 [5053] rsync error: some files could not be transferred (code 23) at main.c(683) [sender=2.6.9]
2009/07/17 00:00:24 [5053] Number of files: 77174
2009/07/17 00:00:24 [5053] Number of files transferred: 5
2009/07/17 00:00:24 [5053] Total file size: 286350806778 bytes
2009/07/17 00:00:24 [5053] Total transferred file size: 124088 bytes
2009/07/17 00:00:24 [5053] Literal data: 60372 bytes
2009/07/17 00:00:24 [5053] Matched data: 63716 bytes
2009/07/17 00:00:24 [5053] File list size: 1450907
2009/07/17 00:00:24 [5053] File list generation time: 22.180 seconds
2009/07/17 00:00:24 [5053] File list transfer time: 0.000 seconds
2009/07/17 00:00:24 [5053] Total bytes sent: 1314
2009/07/17 00:00:24 [5053] Total bytes received: 1512053
2009/07/17 00:00:24 [5053] sent 1314 bytes received 1512053 bytes 64398.60 bytes/sec
2009/07/17 00:00:24 [5053] total size is 286350806778 speedup is 189214.39
2009/07/17 00:00:24 [4247] rsync error: some files could not be transferred (code 23) at main.c(1385) [generator=2.6.9]

I turned off DAAP and UPnP, saved and rebooted. The mirror works fine now. The _NL_SWAP file is gone. I really want to use DAAP, should I set it up differently?

Just make sure that your swap file is set to a drive other than your mirror and you should be fine. Log into admin, select 2 - Services Configuration, M - DAAP/UPNP OPTIONS, 1 - Swap Area Target. You should be able to select the swap area setting before you enable DAAP/uPnP.

now set the swap to Disk-0, turn on daap and upnp and you'll be set.