NASLite Network Attached Storage • View topic - Problem with promis ultra TX2/133 ide controller

View unanswered posts | View active topics

Board index » v1.x NASLite Products » NASLite

All times are UTC - 5 hours [ DST ]

Problem with promis ultra TX2/133 ide controller

Page 1 of 1

[ 5 posts ]

Previous topic | Next topic

Author

Message

Keanu

Post subject: Problem with promis ultra TX2/133 ide controller

Posted: Fri Jul 23, 2004 7:31 am

Joined: Fri Jul 23, 2004 6:53 am
Posts: 3

Hi,
another point:

I want to use the promise ultra TX2/133 ide controller.
Is there any support for that?
during bootup nas is recognizing the disk attached to the controller, but i can not configure them!

Thanks, florian

Top

Ron

Post subject:

Posted: Fri Jul 23, 2004 8:47 am

The promise ultra TX2 is a PCI card bus device and is not supported at this time.

Top

Tony

Post subject:

Posted: Fri Jul 23, 2004 9:36 am

Site Admin

Joined: Tue Jul 13, 2004 4:11 pm
Posts: 1771
Location: Server Elements

We have not tested NASLite using a Promise Ultra TX2 controller, but in theory it should work. Although it will not improve performance on NASLIte unless you use the SMBG or FTPG version in which case a gigabit nic is required.

Make sure that if the board you are using has onboard IDE, it is disabled. NASLite will address only interfaces 0 and 1 - no higher. If you have onboard IDE, in addition, then the TX2 will be 2 and 3, so NASLite will not use it.

It's also important to note that the SMBG or FTPG versions of NASLite have improved IDE support. If the TX2 is in fact 0 and 1 then try setting the drives using a G version and if that works, install a supported Gbit nic.

You definately have options.

Top

jakrog

Post subject:

Posted: Mon Jul 26, 2004 7:15 pm

Joined: Mon Jul 26, 2004 7:13 pm
Posts: 1

Tony wrote:

Although it will not improve performance on NASLIte unless you use the SMBG or FTPG version in which case a gigabit nic is required.

So using a IDE controller card will not improve performance unless i use the gigabit version of NASLite? Is that correct?

Top

Ralph

Post subject:

Posted: Mon Jul 26, 2004 11:04 pm

Site Admin

Joined: Tue Jul 13, 2004 4:01 pm
Posts: 801
Location: ServerElements

Correct.

Top

Page 1 of 1

[ 5 posts ]

Board index » v1.x NASLite Products » NASLite

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 48 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum